Many if not most slide toppers have only one spring which is probably the side that is tight.
How to tighten awning over slide out.
Roll the awning back up to observe how tight it is.
Adjusting slide topper awnings is fairly simple.
Depending on the make and model there is a different method to adjust the tension.
If you are satisfied move on.
However perhaps someone here knows how to tighten the slide out awning.
Look for the pin hole near end of roller.
And rvs with slide outs a compartment that extends out from the main cabin providing extra living quarters are sometimes made with awnings over the slide out.
If not then repeat the previous steps.
Thanks for submitting your question on our ask an rv question page.
Two people will handle the awning arms one at each end while another one will feed the cord into your awning rail.
The roller has a spring in it.
Make sure it will not fall out.
The awning over my slideout is sagging on one end but the other end is tight as both ends should be.
You do not need to put the screws back in.
The awning over the big living room slide collects water because there is not enough tension to keep a constant slope.
The slight slack allows water to puddle then as the puddle gets bigger.
Here is brad taylor showing how to adjust an awning fabric.
How to replace spring on awning slideout in rv adjust slide out cover how to tighten loose motorhome slideout covers tightening the spring on a slide out awning slide out kover ii how to adjust spring slide awning toppers tension adjustment how to tighten a carefree slideout topper how tochange the tension on a carefree of colorado.
Usually takes 2 people.
In order to get the awning up and stable the tension needs to be adjusted to get the fabric taut.
Roller should now be free of mounting hardware.
Put a cotter pin in the hole.
You ll be sitting cool in the shade.
How do you tighten up slideout awnings that are sagging.
It s best to have three people for this job.
Just like that your awning is back in action.
Only rotate the legs one or two turns at a time and don t do more than 4 or 5 total.
Since you do not tell me who manufactured your slideout topper awnings it will be very hard for me to tell you how to adjust the tension on them.
Remove end cap or mount.
Is there a way to adjust the tension on the end of the awning.
I had my slide out awnings installed by the dealer lakeshore rv.
The last step is to reinstall the rv awning.
During regular use of your rv the awning fabric and slide in the awning tube causing alignment is.
Step 5 re install awning.
And i ve called and left a message still awaiting the return.
Roll up topper on roller.
Dear jim well it depends on the size and make of your slide topper.
