If you chose to install a new window the process is very straightforward.
Installing screen panel into storm door.
The splines are pieces of narrow rubber tubing that keep the screen secure around the door frame.
It is intended to give you a good idea of the steps involved when installing an emoc storm and screen door.
Set it and the screen panel in a safe place out of the wind.
Use this measurement to mark the appropriate point on the hinge side z bar with a pencil then use your hacksaw to cut.
This is not an instructional video.
10 80 14 94 6 12 18 24 30 36 42 48 54 60 66 72 78 84 90 96 102 108 114 120 126 132 138 144 150 156 162 168 174 180 186 192 198 204 210 216 222 228 234 240 246 252 258 264 270 276 282.
Pick a flat area near the entry door lay the box flat on the ground fold it open and check to make sure you have all the parts.
Replace it with the new one that has the screen insert already installed.
Use an awl or your screwdriver to pry up the spline at the corner of the frame.
Screw the bolts back into the door and you are finished.
Position the sweep so its weather stripping touches the sill and screw into place.
It should not go in between the screen and the door frame.
Begin the project by folding open the box and removing the glass storm panel.
Working your way down the door slide and snap the retainer into the track until the markings are no longer visible applying pressure as you go.
Pull the splines out of the door frame groove with steady firm pressure.
There is a separate piece of spline for each side of the screen.
Install the handle set and associated hardware of the new door lock.
Get installation instructions for your storm door including preparing the rough opening sealing shimming fastening flashing and water management.
Window screen hanger latches finish mill stamped aluminum used to install 7 16 inches window screens to wood framed windows will install 2 window screens.
Complete the installation by installing the door closer.
Step 3 remove window panes.
Slide the expander off the bottom of the door and install the sweep.
Slide it into the door channel in front of the screen.
Remove the glass and place the screen in the door opening.
Start at the top of the door and hold the retainer at about a 45 degree angle with the edge with writing on it facing you.