Installing Sliding Pocket Doors

Install the door pulls.

Installing sliding pocket doors.

Complete installation of the johnson pocket door and show how to install a pocket door in los angeles. Next install the slider track using the rails that came in your pocket door kit. Any door that could be installed as a hung door can be installed as a pocket door. Drill a hole and chisel a shallow mortise in that jamb for the strike plate which the door latch engages.

If you want to install other hardware be sure that it can be inset into both sides of the door without blocking the door s operation. With strict attention to detail from design through to production cavity sliders offers sliding door products that are high quality reliable and operate smoothly. Install door casing nailing it to the jamb and to pocket door studs. Install the pocket door pulls that accompany the framing kit.

Use a stud finder to locate and mark the stud locations then hammer a nail on the center leaving roughly 1 8 inch sticking out. Then put the hardware and door into the slider track. Cavity sliders usa inc is the premier manufacturer of pocket door hardware. The channel is marked for various door widths so it s easy to cut it to the right length.

The weight of solid wood doors can be a challenge to the successful operation of the runner hardware while the hardware will tend to be pulled out from hollow core composite doors. High quality fully compatible pocket door accessories for use with all our doors and systems. Install a full width strike jamb on the opposite side. Cut through the nailers.

This is where the frame header brackets will rest. Accessories to complete pocket door installations including closing kits door pulls and handles. Build your wall to the correct thickness. Use 6d finish nails to install the top and strike jamb casing.

All finished to an exceptionally high and stylish standard. Be sure to screw the brackets into the studs. Install the pocket door frame measure up from the floor 80 inches leaving anywhere from inches to 1 inches clearance under the door. The pocket door track is a metal channel with wooden nailing strips on each side.